Welcome again to the wonderful but sometimes weird world of wireless comms, written by Joel Young, CTO of Digi International.So all of Tesla's work was cool, but how about a practical use of wireless power for say 10 to 20 feet?
Okay - well I acknowledge that, as cool as Tesla's work was, it probably isn't very practical in today's world for all of the obvious reasons.
Nonetheless, we can still learn a lot from this work as to how it relates to other wireless power solutions under development today. Unfortunately, while promising experimentally, wide availability of products has not yet been realised, but it is only a matter of time and I'm convinced that we will see easy to use, cost effective, personal area wireless power within the next few years.
But how will it work? Other than solutions like harvesting RF, the cornerstone for practical wireless power is related to some type of inductive coupling.
I recognise that some of you physics purists might take exception to my terminology. In any event, the idea is to extend near-field effects over a distance.
In the Tesla solution discussed in the last post, the earth was turned into a giant coaxial cable where energy was transferred via magnetic field, guided by the earth's atmosphere acting as a dielectric, thereby extending the distance of inductive coupling.
In my searching, I've come across another approach for extending the reach of inductive coupling to form what I will call personal area wireless power. The most intriguing methods of promise are variants of something called Resonant Induction.
This work has been pioneered by some really smart people at MIT as part of the MIT Wireless Power Project. Other work, using slightly different techniques has also been developed at the University of Florida.
The concept is to use resonance to extend the distance and "guide" the magnetic flux. I know this sounds a bit strange and I readily admit that I don't completely understand it completely. But you should think about it in the same way you think about a tuning fork. If you strike a tuning fork, you might not be able to hear the sound of its vibrations over much distance, but another tuning fork that has the same resonant frequency, will easily vibrate over some distance.
Remember that the resonant frequency is the natural frequency of vibration. In the concept of the tuning fork, the sound vibrations appear to "tunnel" between the two forks. To do this electromagnetically, we take a Tesla coil and bend it in a circular shape. Next the really cool part - on the ends, where the Tesla coil would typically touch the ground and the air, capacitance plates are placed so the ends look like a capacitor. See the figure below.
From your old circuit days, you might think of it as creating a sort of LC resonator where the resonant frequency is related to the product of the inductance and capacitance.
Using a high resonant frequency, the magnetic flux appears to be "tunneled" to the receiver as long as the receiver has the same resonant frequency.
Even though we use the term "tunneling" as a metaphor, just like the tuning fork, it appears directionless.
Of course distance is still limited to single digit meters and the amount of power will be limited by emissions constraints.
Finally, for the movie fans out there, I personally notice a resemblance to the "Flux Capacitor" - just imagine what could happen if Doc Brown put 1.2 Giga-Watts into one.
In the Tesla solution discussed in the last post, the earth was turned into a giant coaxial cable where energy was transferred via magnetic field, guided by the earth's atmosphere acting as a dielectric, thereby extending the distance of inductive coupling.
In my searching, I've come across another approach for extending the reach of inductive coupling to form what I will call personal area wireless power. The most intriguing methods of promise are variants of something called Resonant Induction.
This work has been pioneered by some really smart people at MIT as part of the MIT Wireless Power Project. Other work, using slightly different techniques has also been developed at the University of Florida.
The concept is to use resonance to extend the distance and "guide" the magnetic flux. I know this sounds a bit strange and I readily admit that I don't completely understand it completely. But you should think about it in the same way you think about a tuning fork. If you strike a tuning fork, you might not be able to hear the sound of its vibrations over much distance, but another tuning fork that has the same resonant frequency, will easily vibrate over some distance.
Remember that the resonant frequency is the natural frequency of vibration. In the concept of the tuning fork, the sound vibrations appear to "tunnel" between the two forks. To do this electromagnetically, we take a Tesla coil and bend it in a circular shape. Next the really cool part - on the ends, where the Tesla coil would typically touch the ground and the air, capacitance plates are placed so the ends look like a capacitor. See the figure below.
From your old circuit days, you might think of it as creating a sort of LC resonator where the resonant frequency is related to the product of the inductance and capacitance. Using a high resonant frequency, the magnetic flux appears to be "tunneled" to the receiver as long as the receiver has the same resonant frequency.
Even though we use the term "tunneling" as a metaphor, just like the tuning fork, it appears directionless.
Of course distance is still limited to single digit meters and the amount of power will be limited by emissions constraints.
Finally, for the movie fans out there, I personally notice a resemblance to the "Flux Capacitor" - just imagine what could happen if Doc Brown put 1.2 Giga-Watts into one.
Previous Weird & Wireless:
- Weird & Wireless: How can wireless power transmission work?
- Weird & Wireless: What about wireless power transmission?
- Weird & Wireless: How can light have temperature?
- Weird & Wireless: CFL, LED, and the incandescent bulb
- Weird & Wireless: Differences between lumens, lux, candelas and watts
- Weird & Wireless: "Line of Site" changing closer to the receiver
- Weird & Wireless: Passive antennas and gain
- Weird & Wireless: What happens when an RF hits an obstacle?
- Weird & Wireless: RF "Line of Sight"
- Weird & Wireless: Signals getting weaker in free space
- Weird & Wireless: Why don't wireless transmissions go on forever?
- Weird & Wireless: Adding wind power to your home
- Weird & Wireless: Why do mobile phones cause noise on my office speaker phone?
- Weird & Wireless: Does unplugging all your wall-warts really matter?
- Weird & Wireless: How did we end up with a kilowatt-hour?
- Weird & Wireless: Why is the use of cell phones discouraged around petrol pumps?
- Weird & Wireless: What is the difference between a human eye and an antenna?
- Weird & Wireless: What's the deal with electronics and radios on airplanes?
- Weird & Wireless: Can batteries be left out in the cold?
- Weird & Wireless: GPS, and how do those satellites know where I am?
- Weird & Wireless: Do microwave ovens cause cancer?
- Weird & Wireless: Why can I use a 2.4-GHz phone and 802.11 network at the same time?
Comments (1)
I must say, that is quite genius. While Resonant Induction can be a little weird and hard for people to understand, I think that the Tuning Fork example is one of the best you can use.
I think it would just take some serious experimenting to figure out how to do it in order to power the world. Tesla was on the verge of discovering how to do it before his funding was cut by JP Morgan, and then shortly after passed away. Its quite unfortunate that Tesla had to go so early. Bright minds like that need to have the chance to pass their knowledge on...
Time Machine anyone, lol
Posted by Matthew | March 20, 2011 2:13 AM
Posted on March 20, 2011 02:13