Microchip combines flexible dc-dc and MCU

Microchip MCP19114 and MCP19115Microchip has expanded its ‘digitally-enhanced power analogue controller’ range of microcontrollers for dc-dc conversion.

These are not for digital-in-the-loop applications. Instead they include all the standard analogue blocks required for a flexible dc-dc controller, plus an over-seeing microcontroller.

MCP19114 and MCP19115 to support fly-back, boost, Cuk and SEPIC topologies – in quasi-resonant (internal comparator) or fixed-frequency forms (internal programmable oscillator).

Supply range is 4.5V to 42V, covering 5, 12, and 24V rails as well as automotive load-dump. Quiescent current is typically 5mA and sleep can be around 30μA.

The step-up PWM controller runs from 31.25kHz to 2MHz, and there two low-side gate drivers with independent dead time control delivering +/-1A at 10V, or +/-0.5A when only 5V is available.

For those close to Microchip products: the analogue PWM controller similar to the MCP1631, and the MCU is largely a PIC12F617.

Inside is programmable: input under/over voltage lock-out, output over-voltage, leading edge blanking (four steps), 6bit slope compensation, and 8bit voltage reference.

A capture-and-compare adds additional control, for dimming, for example, and an I2C serial bus is available.

To go with the chips, there is the MCP19114 ‘flyback standalone evaluation board’ (ADM00578) supporting 0-50V output from 8-14V input.

Development tools include MPLAB X integrated development environment, PICkit 3 (PG164130), PICkit serial analyser (DV164122), and the MPLAB XC8 Compiler.

Both chips are available now: MCP19114 in 4x4mm 24 lead QFN, and MCP19115 in 5x5mm 28 lead QFN.

Loosely, the difference between the two is that, compared with the ..15, the ..14 version loses a few I/O or ADC input lines, and a capture/compare line.

Tags: analogue controller, MCU, MCU Microchip, Microchip products, pwm controller

Related Tech News

Share your knowledge - Leave a comment