Rittal has released a subrack, the Ripac “Easy”, which has been designed for straight-forward installation.

According to the supplier, one problem for subrack assemblers has always been the issue of holding the rail, the side panel, the flange, the screw and screwdriver all at the same time. 

This problem has been addressed by allowing the assembler to hold the side plate and flange together while dropping the pre-assembled rail into position, then screw into place.

The subrack is supplied as a kit with screws pre-inserted in the ends of the horizontal rails, which just drop into slots in the side panels and front flanges.

The screw slots are pre-defined in position on the side plates, which correspond with the standard 160, 220 and 280mm Euroboard depths.   

More information: www.rittal.co.uk